Recently Updated Pages

This wiki-like know-how has been produced by Yedlik AS and Battkomp AS in the years 2020 to 2024 ...

We've received 6 batteries of the model TP-BA150H on 15th August. S/N Repaired befo...

These batteries are replacing the familiar NEE1009-W batteries. The NEE1009-W batteries are in us...

Remove the PH2 screws on the edge of the battery. DO NOT remove the T10 screws on top or bottom ...

We like to use the Daly BMSs from AliExpress, because: waterproof no exposed components feel...

NOTE: This battery needs a key, if the key is missing, to be able to discharge one should sho...

How to open Remove the 4x 6mm HEX bolts - need LOTS of torque because they are glued...

Feedback from actually building it The isolation plates need to be thicker and longer so...

We see three types of Wisper batteries, all 36V: Short brick Long brick Pillion (rare) We...

  24V, 20Ah 8S1P LFP with pouch cells UART communication most likely In this battery, B2 wa...

Battery 36V 15Ah - MH1/17.5Ah MJ1 BH 48V   9Ah MH1/ 10.5Ah MJ1 BH 36V 12Ah MH1/14Ah MJ...

10S1P arrangement, Samsung 25R cells. (High power, low capacity!) The BMS does not actually have ...

This battery was out of balance - one cell is 3.23 while the rest is all 3.33V. CALB-TUV...

The housing is made of two parts: Shiny plastic top layer, onto which the rubber mat i...

Sticker No serial number anywhere on the battery (other than on the BMS itself) Lotsa Polish ...

pin 1: positive+, pin 2: empty, pin 3: negative-

If I touch together the orange and brown signal wires, the charging works.

Reset If the cells are not in deep discharge, the problem will be that the BMS goes into a fault...

We need to build a simplified version of this: https://www.seeedstudio.com/CANBed-FD-Arduino-CAN...